Christopher Athari, DMD, FICOI, FAAIP, is a general dentist and is the practice owner of this Affordable Dentures & Implants-affiliated practice in Mesa, AZ. Dr. Athari and his staff look forward to fulfilling the denture and dental implant needs of patients who travel from Mesa, Tempe, Gilbert, Chandler, Scottsdale, Maricopa, Sun Lakes, Apache Junction, Fountain Hills, Florence, Superior and surrounding communities.
Dentures are mainly made from acrylic due to the ease of material manipulation and likeness to intra-oral tissues, ie. gums. Most dentures made are fabricated from heat-cured acrylic polymethyl methacrylate and rubber-reinforced polymethyl methacrylate.[3] Coloring agents and synthetic fibers are added to obtain the tissue-like shade, and to mimic the small capillaries of the oral mucosa, respectively.[4] However, dentures made from acrylic can be fragile and fracture easily if the patient has trouble adapting neuromuscular control. This can be overcome by reinforcing the denture base with cobalt chromium (Co-Cr). They are often thinner (therefore more comfortable) and stronger (to prevent repeating fractures).
Dental implant-supported dentures have become the best treatment option for patients who are missing all or most of their teeth. The treatment boasts a high success rate, particularly when the patient makes a commitment to the maintenance of good oral health and a qualified dentist performs treatment. However, complications may occur. Here is an overview of the complications that may affect the implants, abutments, and dentures.
The process of fabricating a denture usually begins with an initial dental impression of the maxillary and mandibular ridges. Standard impression materials are used during the process. The initial impression is used to create a simple stone model that represents the maxillary and mandibular arches of the patient's mouth. This is not a detailed impression at this stage. Once the initial impression is taken, the stone model is used to create a 'Custom Impression Tray' which is used to take a second and much more detailed and accurate impression of the patient's maxillary and mandibular ridges. Polyvinylsiloxane impression material is one of several very accurate impression materials used when the final impression is taken of the maxillary and mandibular ridges. A wax rim is fabricated to assist the dentist or denturist in establishing the vertical dimension of occlusion. After this, a bite registration is created to marry the position of one arch to the other.
After graduating from the University of Connecticut Dental School in 2014, Dr. Secola underwent a general practice residency before relocating to Dallas. She enjoys providing high-quality dental care to all patients. Dr. Secola's residency training was at the same facility where Dr. Damon and Dr. Blankenship were residents as well. This program is through the VA hospital system and only allows for 2 residents per year.
The EconomyPlus Denture is made with more expensive teeth for a more natural-looking denture. The denture teeth are set in a wax base so you may try them in to see how the denture will look before it is completed. You may make changes to suit you, consistent with your dental needs. After you have approved the look of your EconomyPlus Denture, the lab will custom finish your denture in the permanent acrylic base material. It's like designing your own smile!
I went for a consultation and it took about 2 hours before seeing the dentist. I was taken in and a full lower x-ray was done, then the dentist came in and looked at it and we discussed my options. My teeth (only 7 left in my mouth) were so bad, that he decided I should go ahead and get a lower plate. He does not recommend a full lower, as there is always trouble with them. A full lower plate is a life changing event. You will not be able to eat any crunchy or hard foods. That's the truth. You will have to eat ground meats and soft foods the rest of your life. They will not tell you that, but I am telling you that.
