Dentures (also known as false teeth) are prosthetic devices constructed to replace missing teeth; they are supported by the surrounding soft and hard tissues of the oral cavity. Conventional dentures are removable (removable partial denture or complete denture). However, there are many denture designs, some which rely on bonding or clasping onto teeth or dental implants (fixed prosthodontics). There are two main categories of dentures, the distinction being whether they are used to replace missing teeth on the mandibular arch or on the maxillary arch.
For most cases, this office is well equipped and able to be of great benefit. If you have a difficult case, you may need someone with a greater level of ability. I am unfortunately unable to rate this practice very high, while mine is a delicate and difficult case, I was left to find another professional to help me complete my implant process that was started with this office.
To clean your dentures, take them out of your mouth and run clean water over them to dislodge any food particles that may be stuck between teeth, along the gum line, or underneath the structure. Then brush the dentures all over with a denture brush or very soft toothbrush using a mild soap or denture cleaner. Be sure not to use any other cleaners, regular toothpaste, or electric toothbrushes as these are all too abrasive and can damage and wear away the denture materials. After cleaning, make sure to rinse them well.
Full-mouth restoration is exactly what it sounds like, restoring natural-looking teeth to both arches. Upper and lower teeth are supported by multiple dental implants — usually four implants per arch — spread evenly across the jawlines. Patients can expect to get their old smile back and a much more natural chewing and eating scenario compared to regular traditional dentures.
Once the numbness wore off I could not open my mouth fully for days. It took a full week before I was out of severe pain. It honestly felt like she had broken my jaw. I decided to tough it out as I have a phobia of dentists. Once the severe pain was over my jaw was sore for the next two months. I'm fairly certain that isn't the norm for routine extractions.
Very poor quality denture. has rough surfaces all over, was not polished, Left corner of my mouth is injured from use of a too large impression tray. I have sores in my mouth and have gone back to using my old partial. I would not recommend Affordable Dentures although their prices are unbeatable. it is unfortunate that they do not produce a quality product.
As far as back office goes, Carlos the assistant has the patience of a saint. Seriously. We had to do a full series of x-rays because my mom couldn't stand up for the pano. My mom had trouble holding still and repeatedly failed to follow instructions. Carlos never stopped smiling and encouraging her. He had a lot of positive energy and kept joking with her throughout, which I know went a long way to making her feel good about the office. He did the same during the other visits, but the x-rays I'm sure were the biggest challenge.
We paid for extraction and dentures and it was for 2 sets one to wear until gums heal and so we did but it took so much time because they said not ready on gums. This went on & on and then they would NOT answer their phone when we called for the permanent set (we paid for) and they would not return messages. So 2 years have gone and I am left with the first set used until gum set and they are awful and this place is in Odessa, Texas. They are cheats and liars.
First of all the facility is not equipped properly, during service you have to spit into a plastic cup which is completely ridiculous. Secondly, they make you wait 9 months instead of 7 to heal your gum after pulling out original teeth. Final product (ultimate fit) break after 2 months in the mouth while eating pasta. Low quality material!!! Fighting to get our money back. :((
Review: The thought of having my teeth pulled and receiving dentures was a very difficult decision for me, however I am more then satisfied with my dentures and the team environment at the Eugene office. Nel was always so very accommodating to my denture needs and Stacy was always helpful and joyful. If I were to give some marketing advice to your clinic I would have wanted to talk with someone who had been through the transition. In addition I have now given referrals to some potential future clients but I don’ believe that there is a way for your office to know that.
Extra care must be taken when handling dentures or partials because they are delicate and could break when dropped. It is also important to prevent dentures or partials from drying out so place them in the specified soaking solution or plain water when not in use. Avoid hot water because this will cause the denture to lose its shape. Brush dentures daily to dislodge food deposits and prevent them from becoming stained.
It is often necessary to pull any remaining damaged teeth before getting dentures. Tooth extraction typically costs $75-$450 per tooth for a simple extraction and $150-$650 or more per tooth for a surgical extraction. Depending on the number of teeth to be pulled, the total cost of getting dentures can be $1,500-$20,000 or more for a full set (uppers and lowers). CostHelper readers report paying $2,000-$18,000 for a full set of removable dentures including tooth extractions and other preparation work, at an average cost of $9,063.
The fabrication of a set of complete dentures is a challenge for any dentist/denturist. There are many axioms in the production of dentures that must be understood; ignorance of one axiom can lead to failure of the denture. In the vast majority of cases, complete dentures should be comfortable soon after insertion, although almost always at least two adjustment visits are necessary to remove the cause of sore spots. One of the most critical aspects of dentures is that the impression of the denture must be perfectly made and used with perfect technique to make an accurate model of the patient's edentulous (toothless) gums. The dentist or denturist must use a process called border molding to ensure that the denture flanges are properly extended. An array of problems may occur if the final impression of the denture is not made properly. It takes considerable patience and experience for a dentist to know how to make a denture, and for this reason it may be in the patient's best interest to seek a specialist, either a prosthodontist or denturist, to make the denture. A denturist is a trained and licensed professional who sees patients in need of dentures, partials, relines or repairs. A denturist not only takes the impression, but makes the entire denture in his or her own laboratory. The denturist then schedules a date for the delivery of the finished dentures to the patient. A general dentist may do a good job making dentures, but only if he or she is meticulous and experienced. Many dentists no longer make dentures themselves. but instead take an impression of the patients' mouth and then either send the impressions to a dental laboratory, which could be anywhere in the world, or send the patient to a denturist. Once the laboratory receives dental impressions of the patient's mouth, the laboratory creates plaster molds from them. The laboratory uses the molds to create the wax rims used to register the patient's bite. These wax rims are returned to the dentist, who uses them to register the patient's bite. The dentist may assist the patient in choosing the correct size of teeth for the dentures, or simply make the selection himself. Once bite registration is completed and the teeth are selected for the dentures, the wax rim is usually returned to the dental laboratory in order to have the denture teeth set into the wax. Once the teeth are set into the wax rim, the result is a prefinished denture that looks almost like the finished product. This prefinished denture is usually returned to the dentist's office and the patient usually has a chance to approve the setup (for immediate or standard dentures) or to try the denture before it is finished. After approval by the patient, the dentist returns the pre-denture to the laboratory for final processing. The finished denture is then returned to the dentist's office for delivery to the patient.
I worked here for six years with the same doctor who was amazing. We got one weeks notice that he was leaving and they brought in a new dentist. The new guy was great too. Everything was fine until I came in to work and found out (from someone coming in to apply for a job, NOT MY BOSS) that both my job and our front desk lady’s job was posted online. We had been denied raises for 6 years because corporate said we were hired on at a rate higher than we should have been. I called my regional manager to ask if I was being fired and was told that they were going to be interviewing to see what kind of talent was out there. Basically they were going to fire people who had worked there for SIX YEARS to hire someone to work for less money. Do not think that you or your family matter to those people! All they care about is the bottom line and you are just a number. Six years I worked there, and I even ran the front and the back when our front desk was out for almost 6 months with open heart surgery.... and that’s how I got treated.
