The main alternatives are a fixed bridge or a dental implant. A dental bridge is made by putting crowns on the teeth at either side of the gap, and then joining these two crowns together by placing a false tooth in the space. This is all made in the laboratory and then the pieces are cemented into place with special adhesives. The bridge can't be removed.
Minor fractures in the teeth or acrylic base can usually be repaired by a dental lab in 1 to 2 days. Denture repair kits are even sold at most drugstores and online to fix minor cracks or replace loose teeth. Repairing the denture properly can be complicated, however, so if denture problems are noticed, it is best to contact a general dentist as soon as possible to arrange the denture repair.
I bought a full upper denture and within months, they were way too loose. I was told by my dentist they would need relining after several months. My dentist now wants $475 to reline and fit these very thin dentures, but she never mentioned I would be charged to have these refitted. After paying $2,500 total (and unexpectedly), I was just wondering Is this the norm? Or was I just unlucky?Answer: Whenever teeth are extracted, the jawbone and gums in the areas where the teeth used to be start to shrink. This shrinkage can continue for the rest of your life, and this is part of the reason that most dentures need to be refit periodically. Because the most rapid jaw shrinkage occurs during the first six months after extractions, it would be quite normal for your dentures to be loose after six months and require relining. Because the need for this additional and continual treatment (refitting) can vary greatly from patient to patient and time to time, it is most often considered as a separate part of your treatment plan, and the time necessary to accomplish this service is billed accordingly.Response provided by the American College of Prosthodontists. Back to top
Generally speaking partial dentures tend to be held in place by the presence of the remaining natural teeth and complete dentures tend to rely on muscular co-ordination and limited suction to stay in place. The maxilla very commonly has more favorable denture bearing anatomy as the ridge tends to be well formed and there is a larger area on the palate for suction to retain the denture. Conversely, the mandible tends to make lower dentures much less retentive due to the displacing presence of the tongue and the higher rate of resorption, frequently leading to significantly resorbed lower ridges. Disto-lingual regions tend to offer retention even in highly resorbed mandibles, and extension of the flange into these regions tends to produce a more retentive lower denture. An implant supported lower denture is another option for improving retention.
Tooth-supported fixed bridge. The most common alternative to dental implants for a single tooth, fixed bridges involve grinding away – in other words, intentionally damaging – healthy adjacent teeth that are used to attach and support the bridge. The tooth-supported bridge does not stimulate natural bone growth beneath it, so the bone may deteriorate over time. Bridges generally fail after 5-10 years because patient have difficulty flossing them, which makes the root surfaces below and around the bridgework highly susceptible to decay.
The EconomyPlus Denture is made with more expensive teeth for a more natural-looking denture. The denture teeth are set in a wax base so you may try them in to see how the denture will look before it is completed. You may make changes to suit you, consistent with your dental needs. After you have approved the look of your EconomyPlus Denture, the lab will custom finish your denture in the permanent acrylic base material. It's like designing your own smile!
An overdenture is a removable dental prosthesis that covers and rests on one or more remaining tooth roots. A removable partial denture is a dental prosthesis that replaces some teeth and is built around existing natural teeth. Both the overdenture and the removable partial denture may be connected to the remaining tooth roots or remaining natural teeth with anchors made of metal or plastic. These connections improve stability and the retention of both prostheses.
