Teeth can fall out for a number of reasons, ranging from genetics to drug abuse. Most commonly, teeth are removed or fall out on their own due to severe tooth decay. Neglect to upkeep oral hygiene or not seeking proper treatment for damaged teeth, can lead to the onset of decay which in turn leads to loss of teeth. Visiting you dentist in 6 month intervals is a good preventive measure to spot any early signs of decay.
Minor fractures in the teeth or acrylic base can usually be repaired by a dental lab in 1 to 2 days. Denture repair kits are even sold at most drugstores and online to fix minor cracks or replace loose teeth. Repairing the denture properly can be complicated, however, so if denture problems are noticed, it is best to contact a general dentist as soon as possible to arrange the denture repair.
I have only 4 teeth on the top of my mouth. This causes me to be pretty depressed. Maybe this is why I fell for it. I went to my free consultation, this I found out later was free because they would get money later. I explained to them I have been told I have a lot of bone loss so worry I am not able to get this done. The doctor came in after the 2d exam and explained to me he could do one with 4 implants. Although not the one I wanted as I want the nonremovable, these were affordable and could be done. They then come in and give you a sheet with the full plan.
My advice is if you're looking for a dentist to assist you in getting dentures, don't do Affordable Dentures. It's all about money not about your oral health. What bad you got your dentures and then forget you? No check up too see if you're healing properly. Actually it's my fault for my bad teeth. But when I have to make a loan for 1485.00 and have to pay back 3,300.00 just for a top denture and extractions. Least my dentist could have put forth a little more effort to look like he was doing the job I paid for.
I started getting bone protruding hurting so I called to see about going in and was told he couldn't see me till Monday. So I asked for my pain medicine to be refilled since I had to get through Friday till Monday. And the receptionist politely told me "no", that he wasn't in and told me just to rinse with warm salt water. I did what I was told and suffered through my weekend. By the time I was finally to be seen my dentist didn't even come in to see his handiwork.
Remember: You can do serious harm to your denture and to your health by trying to adjust or repair your denture. Using a do-it-yourself kit can damage the appliance beyond repair. Glues sold over-the-counter often contain harmful chemicals and should not be used on a denture. If your denture breaks, cracks or chips, or if one of the teeth becomes loose, call your dentist immediately. In many cases, dentists can make necessary adjustments or repairs, often on the same day. Complicated repairs may require that the denture be sent to a special dental laboratory.
Throughout your lifetime, dentures will need to be replaced and adjusted which can become time consuming and expensive. It is a simple fact that dentures start to become loose and can break through normal activities such as talking, eating, etc. If a denture arch breaks, it may be possible to repair but in some cases it will need to be replaced entirely.
The first visit was nice enough. The receptionists were polite even if they didn't seem to have a clue what they were doing. The only bad experience I had was a very rude lady who dealt with the mountains of paperwork I was filling out. You could clearly tell that she hated her job. With that being said you run into unpleasant people every day and unless you are incredibly thin skinned it shouldn't bother you. It was the least of my problems.
The process of fabricating a denture usually begins with an initial dental impression of the maxillary and mandibular ridges. Standard impression materials are used during the process. The initial impression is used to create a simple stone model that represents the maxillary and mandibular arches of the patient's mouth. This is not a detailed impression at this stage. Once the initial impression is taken, the stone model is used to create a 'Custom Impression Tray' which is used to take a second and much more detailed and accurate impression of the patient's maxillary and mandibular ridges. Polyvinylsiloxane impression material is one of several very accurate impression materials used when the final impression is taken of the maxillary and mandibular ridges. A wax rim is fabricated to assist the dentist or denturist in establishing the vertical dimension of occlusion. After this, a bite registration is created to marry the position of one arch to the other.
Fixed bridges are another tooth replacement option that are typically more durable and a more permanent solution than denture arches. A bridge spans the length of at least three teeth to replace a missing tooth or teeth in between. Bridges are cheaper than dental implants but do not offer all the same benefits when compared to replacing a missing tooth with an implant.
Dentures must be handled with great care and placed in a container of water or denture cleaner when not being worn. They should never be placed in hot water, for they can be damaged or warped. They must be cleaned daily using a soft toothbrush with soap and water. The mouth should be rinsed daily without the dentures in place to clean off any plaque and reduce the risk of infection like candidiasis.
Stability is the principle that describes how well the denture base is prevented from moving in a horizontal plane, and thus sliding from side to side or front to back. The more the denture base (pink material) is in smooth and continuous contact with the edentulous ridge (the hill upon which the teeth used to reside, but now only residual alveolar bone with overlying mucosa), the better the stability. Of course, the higher and broader the ridge, the better the stability will be, but this is usually a result of patient anatomy, barring surgical intervention (bone grafts, etc.).
Denture adhesives, also called denture adherents, are creams, powders, wafers or strips that are used to hold dentures firmly in place. The adhesive also helps form a seal that keeps food particles from sticking between the dentures and gums. Adhesive is applied to clean dentures, which are then positioned in the mouth and held in place for a few seconds, according to the manufacturer’s instructions.
Eating with new dentures will take a little practice and may be uncomfortable for some wearers for a few weeks. To get used to the new denture, start with soft foods cut into small pieces. Chew slowly using both sides of your mouth. As you get used to new dentures, add other foods until you return to a normal diet. Be cautious with hot or hard foods and sharp-edged bones or shells. And, avoid foods that are extremely sticky or hard. You should also avoid chewing gum while you wear the denture. Also, don't use toothpicks while wearing dentures.
First of all the facility is not equipped properly, during service you have to spit into a plastic cup which is completely ridiculous. Secondly, they make you wait 9 months instead of 7 to heal your gum after pulling out original teeth. Final product (ultimate fit) break after 2 months in the mouth while eating pasta. Low quality material!!! Fighting to get our money back. :((
She then said, "You come when I tell you to, or you won't get an adjustment or repair." So I haven't been back. I live with the worst excuse for a set of partials ever made. The chewing surfaces are almost non-existent. The lowers cannot be worn. The uppers continue to chip. These substandard, inferior teeth are causing pain and suffering as well as embarrassment by not being wearable.
I had a really great experience with Affordable Dentures and Implants. My mom has always been afraid of dentists and didn't take care of her teeth. She also had a stroke a few years back which has created a few more barriers to treatment. It's difficult to explain to anyone who doesn't personally know a stroke survivor, but she gets antsy pretty quickly and can be a bit difficult to work with at times. She's also physically handicapped and can't use her left side, plus is having trouble transferring from her wheelchair to other seats, getting into a helpful position, and following directions, so it's a bit of a unique situation.
Although dental implant success rates are high, there are cases in which the implant will fail. Most cases of implant failure can be prevented if the patient maintains his or her oral health and chooses a qualified implant dentist to plan and perform the procedure. Dental implants are more likely to fail in the maxilla (upper jaw) than in the mandible (lower jaw). Possible reasons for implant failure include:
Partial dentures are a removable appliance that consists of artificial or prosthetic teeth attached to a gum-colored plastic-acrylic base. Partial dentures can be secured more and held in place by a metal framework or tooth-colored attachments. Partial dentures are used for patients who are missing one or more natural teeth, but not all of their teeth. These dentures work with both the upper and lower jaw, remaining secure in either location during use.
Most partial dentures contain a thin metal framework that is designed to rest close to your gums and allow for a smooth, non-bulky feel. The framework is supported by your natural teeth to provide a reliable, secure appliance that is easy to use. Where teeth are missing, natural-looking replacement teeth are attached to the frame, and gum-colored acrylic is used to make the appliance blend with your mouth. Again, your mouth and your needs are unique, and Dr. Yonan, Scott, Quigley, Fairbanks & Bushnell work with skilled technicians to create a solution that is comfortable and esthetic.
She then said, "You come when I tell you to, or you won't get an adjustment or repair." So I haven't been back. I live with the worst excuse for a set of partials ever made. The chewing surfaces are almost non-existent. The lowers cannot be worn. The uppers continue to chip. These substandard, inferior teeth are causing pain and suffering as well as embarrassment by not being wearable.
Retention is the principle that describes how well the denture is prevented from moving vertically in the opposite direction of insertion. The better the topographical mimicry of the intaglio (interior) surface of the denture base to the surface of the underlying mucosa, the better the retention will be (in removable partial dentures, the clasps are a major provider of retention), as surface tension, suction and friction will aid in keeping the denture base from breaking intimate contact with the mucosal surface. It is important to note that the most critical element in the retentive design of a maxillary complete denture is a complete and total border seal (complete peripheral seal) in order to achieve 'suction'. The border seal is composed of the edges of the anterior and lateral aspects and the posterior palatal seal. The posterior palatal seal design is accomplished by covering the entire hard palate and extending not beyond the soft palate and ending 1–2 mm from the vibrating line.
