In addition to directing the fabrication of the denture, dentists provide information to patients on the proper care and use of the appliance. Dentures must be cared for properly. For example, placing removable dentures in water or a denture cleanser solution, when they are not being worn, helps the denture retain its shape, remain pliable and keeps it from drying out. Dentures should never be placed in hot water as it could cause them to warp.
BOAZ, ALABAMA -- I had the more expensive flexible partials made there about two weeks after I had several teeth pulled. The roots had broken off the teeth when the free clinic pulled them. I told the technician this and she failed to tell me that I should wait until the tooth fragments worked their way out of my gums and as a result there is a big gap between the outside of my gum and the denture. Big enough to pack a lunch in when I eat. Then the technician actually moved the mold cup before the mold was set then pushed it back into place.
The denture itself is not very good. Again, I fault this due to a low paid lab worker, who is probably texting while he makes the denture. It clearly did not fit properly, too much in one area, too little in another. I am glad that I have had a partial for years and an upper for years, as I know what can be done to alleviate the pressure points. I had to remove material in several spots on the lower edges of the denture, to keep it from bruising my gums.
Implants: An implant is a metal post that is inserted into the bone of the upper or lower jaw. This post is then used to replace a single tooth by attaching a crown to it, or multiple teeth by attaching a bridge to multiple implants. Implants are the most expensive option for tooth replacement, but implants simulate natural teeth better than any of the other options.
Went in Affordable Dentures in Covington Louisiana off Pinnacle Parkway to have upper and lower partial repaired. Was told I needed new ones and two teeth extracted. I did need two teeth pulled so dentist gave me antibiotics and told me to come back in a couple of days so I did. The extraction hurt really bad even though my mouth was numb. The next morning once the numbness wore off I realized dentist had pulled one of the wrong teeth. He pulled a wisdom tooth that wasn’t bothering me. Went to office to complain then went to my dentist who cleans my teeth and he told me that the dentist at Affordable Dentures should have never tried to pull my wisdom tooth. That an oral surgeon should have done that. I was in so much pain my blood pressure was super high. Dentist at Affordable Dentures only gave me ** 800 mg so my regular dentist had to give me pain medication once my mouth was healed.
Although dental implant success rates are high, there are cases in which the implant will fail. Most cases of implant failure can be prevented if the patient maintains his or her oral health and chooses a qualified implant dentist to plan and perform the procedure. Dental implants are more likely to fail in the maxilla (upper jaw) than in the mandible (lower jaw). Possible reasons for implant failure include:
Support is the principle that describes how well the underlying mucosa (oral tissues, including gums) keeps the denture from moving vertically towards the arch in question during chewing, and thus being excessively depressed and moving deeper into the arch. For the mandibular arch, this function is provided primarily by the buccal shelf, a region extending laterally from the back or posterior ridges, and by the pear-shaped pad (the most posterior area of keratinized gingival formed by the scaling down of the retro-molar papilla after the extraction of the last molar tooth). Secondary support for the complete mandibular denture is provided by the alveolar ridge crest. The maxillary arch receives primary support from the horizontal hard palate and the posterior alveolar ridge crest. The larger the denture flanges (that part of the denture that extends into the vestibule), the better the stability (another parameter to assess fit of a complete denture). Long flanges beyond the functional depth of the sulcus are a common error in denture construction, often (but not always) leading to movement in function, and ulcerations (denture sore spots).
Medically, the consequences of not replacing missing teeth include unwanted and unhealthy nutritional changes. There are also potential risks of diabetes, obesity, heart disease, depression, and an increase in the likelihood of developing cancer. These are all prominent health risks that are avoidable by providing a dental structure with partial dentures or another quality tooth replacement option.
Fifty-four complete-denture wearers were interviewed one year after they had been fitted with the dentures. Their opinions and reactions were noted and the answers given to standard questions were analysed for inter-correlations and for correlations with findings in earlier series of clinical and roentgenological investigations. Most of the patients were satisfied with the fit, aesthetic effect of the denture and ability to chew and speak. Many of the patients reported oral parafunctions. Roughly every fourth patient used sedatives because they felt restless and nervous.
The process of fabricating a denture usually begins with an initial dental impression of the maxillary and mandibular ridges. Standard impression materials are used during the process. The initial impression is used to create a simple stone model that represents the maxillary and mandibular arches of the patient's mouth. This is not a detailed impression at this stage. Once the initial impression is taken, the stone model is used to create a 'Custom Impression Tray' which is used to take a second and much more detailed and accurate impression of the patient's maxillary and mandibular ridges. Polyvinylsiloxane impression material is one of several very accurate impression materials used when the final impression is taken of the maxillary and mandibular ridges. A wax rim is fabricated to assist the dentist or denturist in establishing the vertical dimension of occlusion. After this, a bite registration is created to marry the position of one arch to the other.
Our process allows most patients to arrive early in the morning to make impressions for your denture, have your extractions done during the day, and receive your dentures by the end of the day. With our DDS All-In-One Solution, you could have an all-new smile in the same day, thanks to our state-of-the-art 3D X-ray technology. This set of teeth, although temporary, locks into place, meaning you can immediately begin the transition from eating softer foods, to eating the foods you want again.
Other denture cleaning methods include enzymes, ultrasonic cleansers and microwave exposure.[32] A Cochrane Review found that there is weak evidence to support soaking dentures in effervescent tablets or in enzymatic solutions and while the most effective method for eliminating plaque is not clear, the review shows that brushing with paste eliminates microbial plaque better than inactive methods. There is a need for studies to provide reports about the cost of materials and the negative effects that may be associated with their use as these factors could affect the acceptability of such materials by patients which will in turn affect their effectiveness in a daily setting in the long term. Additionally putting dentures into a dishwasher overnight can be a hndy short cut when away from home. Additionally, further studies comparing the different methods of cleaning dentures are needed.[39]
First and Foremost, this is the nicest and cleanest dental office I have ever been in !! I am always very nervous to go to the dentist and Dr Athari and his staff made me feel very comfortable. I would highly recommend going to this office and ONLY this office. My tooth ache is finally gone, and Dr Athari gave me my smile back :) I could not thank Affordable Dentures Mesa enough !!!!
HOME About Us Meet Dr. Scott Meet Dr. Yonan Meet Dr. Bushnell Meet Dr. Wasserman Meet Dr. Fairbanks Meet Dr. Quigley Meet Our Team Reviews New Patients First Visit Financial Info Patient Forms Online Bill Pay Services Cleaning and Prevention Cosmetic Dentistry Extractions & Preservation Family Dentistry Oral Appliances Orthodontics Sedation Dentistry Technology Tooth Replacement Contact Us Book Online Refer a Friend 541-383-0754
Although dental implant success rates are high, there are cases in which the implant will fail. Most cases of implant failure can be prevented if the patient maintains his or her oral health and chooses a qualified implant dentist to plan and perform the procedure. Dental implants are more likely to fail in the maxilla (upper jaw) than in the mandible (lower jaw). Possible reasons for implant failure include:
It was our impression from viewing the video that this technique is very dependent on the dentist's skill in performing the needed steps (more so than with conventional construction, primarily due to time constraints needed to accomplish certain steps, and accomplish them the first time, properly, before the denture materials set). So in that regard, likely the dentist who fabricated your mother's denture is due as much credit as the system itself.
CONOVER, NORTH CAROLINA -- This place is as crooked as it gets. I went over with the dentist several times the teeth I wanted extracted and he still pulled a perfectly good tooth. The business is so crappy that the owner won't even talk to me or look at the big cavity in the tooth beside the good one he pulled. It had a hole in it about as big around as a cigarette. I was told I would have to pay again to have it removed period. I think it was done just out of greed to make more money. I'll never go there again and I would suggest you don't go either.
Partial Dentures: Partial dentures can either be made with a plastic base or a metal framework that supports the number of teeth that need to be replaced. It is held in the mouth by using clasps and rests that are carefully adapted around the natural teeth. The partial denture that uses a metal framework is the traditional design, due to the rigidity and strength of the metal. Plastic partial dentures have normally been used as emergency or temporary replacements of missing teeth, allowing the gums and bone to heal before a definitive restorative solution is obtained. Recently, however, various materials such as Valplast have been developed to provide durable, flexible alternatives in certain situations.
Retention is the principle that describes how well the denture is prevented from moving vertically in the opposite direction of insertion. The better the topographical mimicry of the intaglio (interior) surface of the denture base to the surface of the underlying mucosa, the better the retention will be (in removable partial dentures, the clasps are a major provider of retention), as surface tension, suction and friction will aid in keeping the denture base from breaking intimate contact with the mucosal surface. It is important to note that the most critical element in the retentive design of a maxillary complete denture is a complete and total border seal (complete peripheral seal) in order to achieve 'suction'. The border seal is composed of the edges of the anterior and lateral aspects and the posterior palatal seal. The posterior palatal seal design is accomplished by covering the entire hard palate and extending not beyond the soft palate and ending 1–2 mm from the vibrating line.
Dental adhesives are safe as long as they are used as directed. If the denture is well-fitting and the adhesive is only used to give added stability, there should be no ill effects. If adhesives are used excessively to fill voids for an ill-fitting denture, they can be harmful to the underlying soft and hard tissues. Occasionally, in these cases, inflammation of the soft tissues can result. In addition, because of its movement on the soft tissue and underlying bone, an ill-fitting denture can cause bone loss.
