Two to six dental implants that support a removable denture plate can cost $3,500-$30,000 or more depending on the number and type of implants (mini-implants are less expensive), denture materials (in some cases an existing denture plate can be adapted for use with implants) and any other procedures needed. A full set (upper and lower) of implants and dentures can cost $7,000-$90,000 or more.
If cared for properly, dentures should last a minimum of 5 years. Over time, the bone shrinks and causes the denture to become loose. The rate that this happens varies with each individual, but can be controlled by visiting a dentist regularly to ensure that the denture is fitting properly. An ill-fitting denture causes the bone to shrink more rapidly. To prolong the life of a denture, a dentist will often use a denture liner to refit the internal surface of the denture to the oral tissues.
Removable partial dentures. Although these don't require grinding down adjacent teeth, they are not nearly as stable or comfortable as dental implants and can affect speech and eating. This type of restoration is less expensive but doesn’t look as natural or function as well as an implant-supported crowns. The bone underneath a removable partial denture may deteriorate over time, changing the appearance of your smile and face.
Dentures must be handled with great care and placed in a container of water or denture cleaner when not being worn. They should never be placed in hot water, for they can be damaged or warped. They must be cleaned daily using a soft toothbrush with soap and water. The mouth should be rinsed daily without the dentures in place to clean off any plaque and reduce the risk of infection like candidiasis.
The process of fabricating a denture usually begins with an initial dental impression of the maxillary and mandibular ridges. Standard impression materials are used during the process. The initial impression is used to create a simple stone model that represents the maxillary and mandibular arches of the patient's mouth. This is not a detailed impression at this stage. Once the initial impression is taken, the stone model is used to create a 'Custom Impression Tray' which is used to take a second and much more detailed and accurate impression of the patient's maxillary and mandibular ridges. Polyvinylsiloxane impression material is one of several very accurate impression materials used when the final impression is taken of the maxillary and mandibular ridges. A wax rim is fabricated to assist the dentist or denturist in establishing the vertical dimension of occlusion. After this, a bite registration is created to marry the position of one arch to the other.