It takes practice to put in and take out a removable partial denture. It may feel a bit odd or tight for the first few weeks. But in time, you should get used to it. Never force the denture into place by biting down. This could bend or break the clasps or damage your teeth. If you have a problem with your new partial denture, talk with your dentist.
The general rule is: brush, soak and brush again. Always clean your denture over a bowl of water or a folded towel in case you drop it. Brush your denture before soaking them, to help remove any bits of food. Using an effervescent (fizzy) denture cleaner will help remove stubborn stains and leave your denture feeling fresher - always follow the manufacturer's instructions. Then brush the denture again, as you would your own teeth, being careful not to scrub too hard as this may cause grooves in the surface.
As far as back office goes, Carlos the assistant has the patience of a saint. Seriously. We had to do a full series of x-rays because my mom couldn't stand up for the pano. My mom had trouble holding still and repeatedly failed to follow instructions. Carlos never stopped smiling and encouraging her. He had a lot of positive energy and kept joking with her throughout, which I know went a long way to making her feel good about the office. He did the same during the other visits, but the x-rays I'm sure were the biggest challenge.
Implant technology can vastly improve the patient's denture-wearing experience by increasing stability and preventing bone from wearing away. Implants can also aid retention. Instead of merely placing the implants to serve as blocking mechanism against the denture's pushing on the alveolar bone, small retentive appliances can be attached to the implants that can then snap into a modified denture base to allow for tremendously increased retention. Available options include a metal "Hader bar" or precision balls attachments.
While wearing removable dentures, patients should not chew gum or use toothpicks. In addition, patients need to be careful when eating food that is hot or hard, as well as anything with bones or shells. It may take a while to get used to chewing with dentures, so Dallas Laser Dentistry suggests patients start with softer foods that are cut into small pieces. Chewing slowly and using both sides of the mouth may also help some patients.
Dentures are mainly made from acrylic due to the ease of material manipulation and likeness to intra-oral tissues, ie. gums. Most dentures made are fabricated from heat-cured acrylic polymethyl methacrylate and rubber-reinforced polymethyl methacrylate.[3] Coloring agents and synthetic fibers are added to obtain the tissue-like shade, and to mimic the small capillaries of the oral mucosa, respectively.[4] However, dentures made from acrylic can be fragile and fracture easily if the patient has trouble adapting neuromuscular control. This can be overcome by reinforcing the denture base with cobalt chromium (Co-Cr). They are often thinner (therefore more comfortable) and stronger (to prevent repeating fractures).
If you’ve had a metal RPD, you know how cumbersome and heavy they can be. Dentists often see them damage remaining teeth and injure the inside of the mouth. Ultaire™ AKP partial dentures are 60% lighter than metal frames! The polymer was formulated to be lightweight as well as strong, similar to polymers used in hip implants. This creates partial dentures that are comfortable, durable and biocompatible, meaning they are safe to have in your body. Unlike metal, Ultaire™ AKP is non-toxic, non-irritating and nickel-free.
Teeth can fall out for a number of reasons, ranging from genetics to drug abuse. Most commonly, teeth are removed or fall out on their own due to severe tooth decay. Neglect to upkeep oral hygiene or not seeking proper treatment for damaged teeth, can lead to the onset of decay which in turn leads to loss of teeth. Visiting you dentist in 6 month intervals is a good preventive measure to spot any early signs of decay.
