_{I went to Affordable Dentures & Implants on 1/4/17 to get a full set of dentures.  Before I went I, I had watched youtube videos to see the issues and complaints that people had about wearing dentures.  I was surprised that Dr. Athari immediately addressed the same issues.  The first thing he said to me was, " Dentures are not fun".  I appreciated the honesty but still wanted them.  So he suggested that I get dentures on the top and then wait and or save up to get implants on the bottom.  This was to avoid the problem that most people have with the dentures on the bottom moving so much.  I was curious about how much that would be so the administrative assistant typed up and printed out a detailed treatment plan.  After she informed me that the total cost wasn't due up front, I realized that it was doable.  I just got my upper dentures done today and I am really pleased.  I can't wait to get my implants.  Thank you Dr. Athari.}
^{Once the numbness wore off I could not open my mouth fully for days. It took a full week before I was out of severe pain. It honestly felt like she had broken my jaw. I decided to tough it out as I have a phobia of dentists. Once the severe pain was over my jaw was sore for the next two months. I'm fairly certain that isn't the norm for routine extractions.}
Although dental implant success rates are high, there are cases in which the implant will fail. Most cases of implant failure can be prevented if the patient maintains his or her oral health and chooses a qualified implant dentist to plan and perform the procedure. Dental implants are more likely to fail in the maxilla (upper jaw) than in the mandible (lower jaw). Possible reasons for implant failure include:
^{I went back anyway. When looking into my mouth, ** told me, "Nothing is wrong with the partial. It'€™s you." You have a lip like Elvis. You snarl like Elvis and that'€™s why you think the teeth look funny." I am 61 years old and never in my life have I been told I look like Elvis. I have never had elevated teeth on one side, either. I asked to speak to the dentist and in came Dr. **, owner of the practice. She looked at my mouth and told me I shouldn't criticize her work and I should leave. I asked her to take the partial and make the teeth the same length.}
Removable partial dentures usually consist of replacement teeth attached to pink or gum-colored plastic bases. Depending on your needs, your dentist will design a partial denture for you. A partial denture may have a metal framework and clasps that connect to your teeth, or they can have other connectors that are more natural looking. In some cases, a removable partial denture is made to attach to your natural teeth with devices called precision attachments. Precision attachments are generally more esthetic than clasps. 
_{Removable partial dentures start at $300 -$500, average around $700-$1,800,and can cost $2,000-$4,000 or more in gold (instead of acrylic or another metal). Partial dentures use a metal framework to hold artificial teeth in place, and can be attached to natural teeth with metal clasps or with precision attachments that are nearly invisible but require crowns on the real teeth.}
It’s important to take good care of them so they stay fresh and comfortable in your mouth. Adopting a daily cleaning regime is important to keep them looking their best. To help remove tough stains, soak your partial dentures in a denture cleaning solution, such as Poligrip Overnight Whitening Daily Cleanser or Poligrip 3 Minute Daily Cleanser, as indicated by the directions on the pack.

There is no phone number for the actual dentist office so I had to make an appointment thru a representative in N.C. I drive 45 miles to the office only to find out they were closed! I called customer service back to find out what's going on and they didn't even have record of me having an appointment! So I angrily drive another 45 miles back home! I made another appointment but after reading all the negative reviews on them, I'm thinking it was a blessing in disguise that my appointment got screwed up and decided I am going to seek services with anyone but Affordable Dentures!

Dr. Athari's dental center has an on-site dental lab that fabricates new dentures and provides repairs and relines, often with same-day service. Being able to provide dentures in a day is a significant advantage, especially for patients who have traveled far distances to visit the practice. The on-site lab also eliminates the need to use outside commercial labs, which helps keep our fees low.

Denture cleanser tablets are dropped into warm water to create an effervescent solution. Dentures are removed from the mouth and placed in the solution.  Soaking dentures in the cleaning solution helps kill germs that can cause odor. The amount of time dentures should be soaked—from a few minutes to overnight—depends on the manufacturer’s instructions.

They hurt my mom and the whole thing was a rip off we went in to get dentures and shave my moms now and when the swelling went down the dentures didn't fit my mother spent over thousand dollars and Theywould not replace the dentures so it was a very bad experience they should be responsible for those dentures after 30 days they should replace the dentures I shouldn't even put them in their mouth they don't fit

Throughout the years, a key driver of our expansion (now more than 230 affiliated practice locations...and counting!) has been Affordable Care, a dental support organization that equips affiliated practice owners to meet their ever-growing patient needs. Affordable Care provides lab and business services through a nationwide network of on-site Affordable Dentures Dental Laboratories (ADDL) and extensive nonclinical support.
When I arrived for my appointment, they said I did not have an appointment and they had no fax from a doctor. They did tell me that they would fit me in but later they acted as though I was telling them a lie, or that I called a different office which according to my cellphone, I had the correct place. The dentist talked to me like I was dirt. I was just trying to tell him that I had this conversation with the lady at that office and then I heard the woman's voice and recognized it as the lady that I spoke with on the phone. I did point at her and say that it was her that I had talked to and she yelled at me not to point at her.
^{They do not use insurance, so don't ask. It's cash or credit card up front. I paid $1,330.00 for 7 extractions, a temporary denture till I heal and a permanent denture within a year. I know first hand that going the other way with a super good dentist, would have resulted in an Oral Surgeon, a Dentist and an expensive Denture Lab. It would have cost me over $5,000 if I had gone the best way... I made an appointment for a week later, to have the teeth removed and before that I went one morning to have my form made, so the temporary denture could be ready for the extraction day... The following lines are my thoughts about the people there...}
The fabrication of a set of complete dentures is a challenge for any dentist/denturist. There are many axioms in the production of dentures that must be understood; ignorance of one axiom can lead to failure of the denture. In the vast majority of cases, complete dentures should be comfortable soon after insertion, although almost always at least two adjustment visits are necessary to remove the cause of sore spots. One of the most critical aspects of dentures is that the impression of the denture must be perfectly made and used with perfect technique to make an accurate model of the patient's edentulous (toothless) gums. The dentist or denturist must use a process called border molding to ensure that the denture flanges are properly extended. An array of problems may occur if the final impression of the denture is not made properly. It takes considerable patience and experience for a dentist to know how to make a denture, and for this reason it may be in the patient's best interest to seek a specialist, either a prosthodontist or denturist, to make the denture. A denturist is a trained and licensed professional who sees patients in need of dentures, partials, relines or repairs. A denturist not only takes the impression, but makes the entire denture in his or her own laboratory. The denturist then schedules a date for the delivery of the finished dentures to the patient. A general dentist may do a good job making dentures, but only if he or she is meticulous and experienced. Many dentists no longer make dentures themselves. but instead take an impression of the patients' mouth and then either send the impressions to a dental laboratory, which could be anywhere in the world, or send the patient to a denturist. Once the laboratory receives dental impressions of the patient's mouth, the laboratory creates plaster molds from them. The laboratory uses the molds to create the wax rims used to register the patient's bite. These wax rims are returned to the dentist, who uses them to register the patient's bite. The dentist may assist the patient in choosing the correct size of teeth for the dentures, or simply make the selection himself. Once bite registration is completed and the teeth are selected for the dentures, the wax rim is usually returned to the dental laboratory in order to have the denture teeth set into the wax. Once the teeth are set into the wax rim, the result is a prefinished denture that looks almost like the finished product. This prefinished denture is usually returned to the dentist's office and the patient usually has a chance to approve the setup (for immediate or standard dentures) or to try the denture before it is finished. After approval by the patient, the dentist returns the pre-denture to the laboratory for final processing. The finished denture is then returned to the dentist's office for delivery to the patient.
This Dr Baumgarden smelled like alchohol and was very rude to me as a patient and the way he talked to the assistants was uncalled for. I have spent over 30 years in the customer service business and if I treated customers as he does I would not have a job. I do realize that everyone has a bad day but this is my second time here and he was like this both times!
One of the major treatments for dealing with missing teeth has always been dentures. Known by its less flattering name ‘false teeth’, there is a certain stigma that has unfairly dogged the use of dentures. This is mainly because old dentures are known to be wobbly, ill-fitting and artificial looking. However, thanks to advancements in modern dentistry, today’s dentures no longer conjure images of fake-looking choppers.
The process of fabricating a denture usually begins with an initial dental impression of the maxillary and mandibular ridges. Standard impression materials are used during the process. The initial impression is used to create a simple stone model that represents the maxillary and mandibular arches of the patient's mouth. This is not a detailed impression at this stage. Once the initial impression is taken, the stone model is used to create a 'Custom Impression Tray' which is used to take a second and much more detailed and accurate impression of the patient's maxillary and mandibular ridges. Polyvinylsiloxane impression material is one of several very accurate impression materials used when the final impression is taken of the maxillary and mandibular ridges. A wax rim is fabricated to assist the dentist or denturist in establishing the vertical dimension of occlusion. After this, a bite registration is created to marry the position of one arch to the other.

Teeth can fall out for a number of reasons, ranging from genetics to drug abuse. Most commonly, teeth are removed or fall out on their own due to severe tooth decay. Neglect to upkeep oral hygiene or not seeking proper treatment for damaged teeth, can lead to the onset of decay which in turn leads to loss of teeth. Visiting you dentist in 6 month intervals is a good preventive measure to spot any early signs of decay. 
Dentures Reviews