I bought a full upper denture and within months, they were way too loose. I was told by my dentist they would need relining after several months. My dentist now wants $475 to reline and fit these very thin dentures, but she never mentioned I would be charged to have these refitted. After paying $2,500 total (and unexpectedly), I was just wondering Is this the norm? Or was I just unlucky?Answer: Whenever teeth are extracted, the jawbone and gums in the areas where the teeth used to be start to shrink. This shrinkage can continue for the rest of your life, and this is part of the reason that most dentures need to be refit periodically. Because the most rapid jaw shrinkage occurs during the first six months after extractions, it would be quite normal for your dentures to be loose after six months and require relining. Because the need for this additional and continual treatment (refitting) can vary greatly from patient to patient and time to time, it is most often considered as a separate part of your treatment plan, and the time necessary to accomplish this service is billed accordingly.Response provided by the American College of Prosthodontists. Back to top
Occasionally, denture wearers may use adhesives. Adhesives come in many forms: creams, powders, pads/wafers, strips or liquids. If you use one of these products, read the instructions, and use them exactly as directed. Your dentist can recommend appropriate cleansers and adhesives; look for products with the ADA Seal of Acceptance. Products with the ADA Seal have been evaluated for safety and effectiveness.
Always remove your dentures before sleeping to avoid damaging them, dislodging them, and to give your gums some time to relax. Submerge your dentures fully in warm, but not hot, water to keep them from drying out and becoming misshapen. Only use denture soaking solution if your dentures do not have metal components as the solution can tarnish the metal.
I informed the front desk of needing to get to work. I let the young woman in back know as well. I understood having to wait an hour for the test fitting of the impression. Well without any concern for my time the mold apparently was not handled properly and was broken. Now I have to wait until 2 pm? I was to be at work by noon after informing them I'd be late. Never at Mesquite location again! We have used three other locations without any issues now this and my son had similar treatment!
As far as back office goes, Carlos the assistant has the patience of a saint. Seriously. We had to do a full series of x-rays because my mom couldn't stand up for the pano. My mom had trouble holding still and repeatedly failed to follow instructions. Carlos never stopped smiling and encouraging her. He had a lot of positive energy and kept joking with her throughout, which I know went a long way to making her feel good about the office. He did the same during the other visits, but the x-rays I'm sure were the biggest challenge.
Later that afternoon I came back to have 16 teeth extracted. I got to the office and waited about 30 minutes before I was seen. I got to the back and began injections. After this I went to a full blown panic attack and came close to passing out. The one positive is the dentist who was working on me took it in stride. I wasn't treated disrespectfully and after about 30 minutes the panic subsided and she was able to finish my injections and begin pulling teeth.
